Four-wheel drive operation, Quadra-trac ii operating, Instructions/precautions — if equipped – Jeep 2008 Commander User Manual
Page 290

selector in N (Neutral) for at least one minute after every
five rocking-motion cycles. This will minimize overheat-
ing and reduce the risk of transmission failure during
prolonged efforts to free a stuck vehicle.
CAUTION!
When “rocking” a stuck vehicle by moving between
“First” and R (Reverse), do not spin the wheels faster
than 15 mph (24 km/h), or drivetrain damage may
result.
FOUR-WHEEL DRIVE OPERATION
Quadra-Trac I
ா
Operating
Instructions/Precautions — If Equipped
The Quadra-Trac I
is a single speed (HI range only)
transfer case which provides convenient full-time
4–wheel drive. No driver interaction is required. This
transfer case divides engine torque almost evenly with 48
percent of engine torque to the front axle and 52 percent
of engine torque to the rear axle. The Brake Traction
Control System (BTC), which combines standard ABS
and Traction Control, provides resistance to any wheel
that is slipping to allow additional torque transfer to
wheels with traction.
NOTE:
The Quadra-Trac I
system is not appropriate
for conditions where LOW range is recommended. Refer
to “Off-Road Driving Tips” in this section.
290
STARTING AND OPERATING