Home Legend Valinge - Manual (Page 7)

Doc. ID: 129 Rev: 3 Effective: 1/20/2014 Page | 7
Uninstalling the Floor

If you have to uninstall. Unlock the whole row from another by lifting up and unclick the planks.

Lay the row down.

Slide the planks from each other at the end joints.
Glue Down Installation Procedure
PLEASE NOTE:
ANY EXCESS GLUE WHICH GETS ONTO THE SURFACE OF THE FLOOR MUST BE REMOVED IMMEDIATELY WITH ADHESIVE REMOVER
The steps in glue down method are very similar to the floating installation method. The only difference is the application of the glue to the
subfloor prior to installation. For more detail instruction, see the floating installation section above
Step 1 – Make sure the flooring does not have an attached underlayment. Flooring with attached underlayment cannot be glued down.
Step 2 – Read ALL adhesive manufacturers instruction.
Step 3 – Read the Glue Down Installation Tips in Helpful Pointers section.
Step 4 – Spread the glue
• Spread the glue from the starting line out in the direction of the center of the room, the width of two planks. Or spread only enough
glue to install what can be set within 45 minutes (15 minutes of OPEN TIME and an additional 30 minutes for actual installation. Usually
about two rows width coverage). Different manufacturer may require different open time and set time.
• Repeat with the next two rows, etc.
Step 5 – Begin installation in the same way as floating installation. From beginning to finishing touch.
Accessories
Pictures are for illustrative purposes only. Actual product may differ from pictures.
T-Molding is used to create a transition between floor coverings of similar heights or to cover an
expansion gap.
Stair Nose is used in conjunction with flooring installed on stair steps or finished edge of a higher
level floor like in a sunken living room.
Carpet Reducer (also called Baby Threshold or End Cap) is used to transition floor coverings of
differing heights. This reducer strip is also commonly used to border a fireplace, sliding glass door
and other exterior door jambs.
Hard Surface Reducer is used to transition to another hard surface flooring of different heights
such as tile, vinyl, concrete.