Gastroback 40962 Design Food Processor - Manual (Page 11)

WARNING: Always release the on/off bottom, wait until the motor stops and unplug
the appliance before assembling/disassembling. Always completely assemble your appliance
before you plug the plug into the power point. Only touch the blade on the edge and
handle with care when cleaning. Do not chop extremely hard food, such as ice, coffee
beans or nutmeg.
WARNING: The universal chopping blade is very sharp. Pay attention when handling the
blade. Only touch the blade on the edge and handle with care when cleaning.
1. Place the container on a suitable, stable, dry, and clean working surface. (see:
‘Safeguards for Daily Operation’).
2. Place the bowl on the motorblock turning it anticlockwise until it is securely locked in position.
Do not use any force. The handle should be facing the front which is above the control panel.
3. Place the universal chopping blade on the drive shaft in the middle
of the bowl (picture A). NOTE: Push the blade down until the blade is
situated 2 mm above the bottom of the bowl (picture B). Always place the
blade in the thoroughly cleaned container before filling in any food.
Ensure that the blade is correctly positioned on the circle on the bottom
of the container. The circle must be thoroughly clean and there may
be no residues of food on it. Check whether the blade is positioned
correctly and can move freely.
NOTE: You do not use the disc stem because the blade chops the
food just above the ground of the bowl.
Prepare your food and fill it in the container. Do not overfill the
container. The food may not exceed half of the height of the bowl.
• Cut meat, cheese, onions, and soft frozen food in pieces of about 1 cm.
• Remove uneatable and hard parts of the food: stalks, skins and shells, seeds, bones,
gristle, and tendons.
4. Attach the lid to the bowl (picture C). The feed chute can be
facing either ways: the front with the control panel or the opposite
side. Turn the lid anticlockwise until it is securely locked and in position.
IMPORTANT: The humps of the rim of the lid should align with
the small plastic wings on the bowl. Lower into position. The lid has
to be securely locked.
.
NOTE: The appliance will not turn ‘ON` unless properly assembled.
5. Connect the power plug to a suitable wall power outlet.
6. Start the appliance pressing the ´ON` button (see picture). The motor will start moving
and the food will get processed.
Note: The Food Processor works extremely quick; some kinds of food are processed
within one second.
A
B
C
35
40962_foodprocessor_manual_mai07.qxp 18.07.2007 10:38 Seite 35