Gastroback 42401 Design Toaster Basic - Manual (Page 11)

5. Wipe the exterior of the toaster with a soft dry cloth.
In most cases, this is sufficient, but if there are stains on the housing of the toaster, you may wipe
the exterior of the toaster with a soft damp cloth.
Ensure that no liquids drip on the toaster. Thoroughly dry the housing of the toaster
thereafter.
CAUTION: Do not insert the crumb tray, when it is still wet. Always ensure that the crumb tray
is properly installed before using the toaster again.
6. Insert the crumb tray in the slot at the back of the toaster and push it in gently. Only the knob
of the crumb tray may protrude.
Storage
WARNING: Always unplug the toaster, when it is not in use. Always wait until
the toaster is completely cool before storing. Do not wind the power cord around the toaster!
To move the toaster, grasp it with both hands on the side panels. Always place the toaster
on a stable, clean, and dry surface, where it is save from inadmissible strain (e.g. fall, shock,
frost) and out of reach of young children. Do not place any hard or heavy objects on
the toaster.
You may store the toaster with the bun warmer rack hanging on the two hooks on the rear of
the toaster housing.
Information and Service
Please check www.gastroback.de for further information. For technical support, please
contact Gastroback Customer Care Center by phone: +49 (0)4165/22 25-0 or e-mail
[email protected].
Notes for Disposal
Dispose of the appliance must be effected in accordance with the corresponding local regulati-
ons and requirements for electrical appliances. Please contact your local disposal company.
Warranty
We guarantee that all our products are free of defects at the time of purchase.
Any demonstrable manufacturing or material defects will be to the exclusion of any further
claim and within 2 years after purchasing the appliance free of charge repaired or substitut-
ed. There is no Warranty claim of the purchaser if the damage or defect of the appliance is
caused by inappropriate treatment, over loading or installation mistakes. The Warranty claim
expires if there is any technical interference of a third party without an written agreement.
The purchaser has to present the sales slip in assertion-of-claim and has to bear all charges of
costs and risk of the transport.
25