Gastroback 42428 Design Kettle Pro - Manual (Page 8)

usIng The DesIgn KeTTLe PrO
Before first use
Remove any promotional material attached to your kettle. It is recommended that before first
use, the kettle is filled to the maximum level with cold tap water, boiled and water discarded.
Your kettle will only operate when positioned on the power base with the >On/Off< switch
in the >On< position. The kettle will automatically switch off once the water has boiled.
use
To fill the kettle, remove it from the power base and open lid by pressing the lid release
button. Fill with the desired amount of water.
nOTe! Always fill the kettle between the minimum (500ml) and maximum (1700ml) marks
on the water window. Too little water will result in the kettle switching off before the water
has boiled or reached the selected temperature. Filling above the maximum mark (MAX)
may result in boiling water splashing from the kettle.
Ensure the lid is locked firmly into place. Position the kettle securely onto the power base.
Insert the power plug into a 230/240V power outlet and switch on.
nOTe! This kettle must only be used with the power base supplied. Use caution when
pouring water from your kettle, as boiling water will scald. Do not pour the water too quickly.
The kettle will automatically switch off once the water has boiled. Lift the kettle from the po-
wer base and pour the water. Take care to hold the kettle level, especially when filled to the
maximum level. To re-boil it may be necessary to wait for a few seconds to allow the control
to reset. If further heating of the kettle is not required, switch off at the power outlet,
unplug the power cord and empty the water from the kettle. Replace the kettle onto the
power base and close the lid.
safeTy BOIL Dry PrOTeCTIOn
The kettle is fitted with a safety device, which protects against overheating should the appli-
ance be operated with insufficient water. If this occurs, the kettle will stop heating. Switch
off at the power outlet and allow kettle to cool before refilling. Remove the kettle from the
power base and add water. Return the kettle to the power base. The safety device will then
automatically reset. For additional safety, your kettle is fitted with an additional thermal cut
out. In the event of overheating, the kettle will automatically shut down to prevent further
damage. Should this occur, take your kettle to an authorized service centre.
warnIng! The appliance is designed for boiling of drinking quality water only. Never
use to heat or boil any other liquids or foodstuffs. The lid should always be firmly in place
and locked into the closed position before use.
warnIng! Do not press the lid release button on the handle to open the lid during the
operation. This may result in boiling water splashing from the kettle. Pour out all the hot
water from the kettle before opening the lid to refill.
20