Gastroback 41401 Mincer - Manual (Page 7)

The mincer blocks up permanently
while operating.
The mincer head moves or loosened while
operating.
The mince leaks out at the side of the
closing ring.
Clear a blocking
If the mincer head is blocked no mince comes out of the mincer while operating or the motor stops
moving automatically because of the overload protection.
ATTENTION: If a blocking occurs turn OFF the appliance immediately. Clear the problem
before turning on the motor again.
1. Turn the appliance OFF and then take the feedstick out of the feed funnel.
2. If the motor stopped running because the overload protection turned itself on you have to
turn the appliance OFF to undo the overload protection.
3. Turn the motor ON and OFF by turns to loosen the blocking.
ATTENTION: If the motor still does not start running turn the appliance OFF, pull the plug
and clean the appliance.
• To ensure that the mincer does not seize, never operate it under
excessive pressure. Operate in a slow and constant pace. Do not
try to rush the procedure by pushing down the meat with force.
• For mincing hard ingredients really fine start with the mincer plate
with the bigger holes. Mincing the second time use the finer mincer
plate.
The screw plug loosened. Turn the appliance OFF immediately. Press the
mincer head with one hand against the motorblock using the other
hand to tighten the screw plug turning it clockwise.
The closing ring is not screwed on tight enough. Turn the appliance OFF
immediately and then pull the plug. Tighten the closing ring but do not
overwind the winding. If the problem still occurs disassemble and clean
the appliance.
Possible problem Easy solution
13
OFF the appliance immediately, pull the plug and dry the appliance with a clean cloth.
8. The motor block must only be wiped clean with a moist cloth. Do not clean the motor block
under flowing water, nor should it be immersed in water! Do not use alcohol, benzine, etc.!
9. Grease the mincer plate and knife with salad oil to prevent air corrosion.
Storage
Always clean the appliance before storing.
ATTENTION: Store and use the appliance in a clean, frost free environment where it is
protected from dampness, moistness and immoderate and extraordinary burden (such as:
downfall, beat, overheating, moisture in the motor block). Never lay heavy or hard objects
on top of the appliance.
10.Always assemble the appliance for storing. This way the parts are protected and can not
get lost.
ATTENTION: Never pull, rip, bend, clamp, squish or knot the line cord.
Trouble shooting guide
The mince is not fine enough.
There are still ingredients in the feed funnel
but no mince is coming out of the mincer.
The motor stops running while operating.
After cleaning the motor does not get started
again when turning the appliance ON.
Possible problem Easy solution
Use a smaller mince plate and/or mince the ingredients more then
once.
The mincer is blocked. Turn the appliance OFF immediately and operate
according to the instructions ´Clear a blocking`.
The overload protection might got activated. Turn the appliance OFF
immediately and operate according to the instructions ´Clear a blocking`.
• Is the power cord plugged in?
• The motor might be blocked with some hard substance (for example a
bone). Turn the appliance OFF immediately and pull the plug.
• Disassemble and clean the appliance. Operate according to the
instructions ´Care and cleaning`.
• If the problem is not solved after the cleaning, take the appliance
for technical maintenance and repair to an authorised specialised
reparation shop.
12