Gastroback 42405 Design Wafflemaker Pro - Manual (Page 9)

and warm soapy water (see: ›Care and cleaning‹).
WarNING! Always unplug the appliance and wait for the appliance to cool down, before
cleaning. Do not pour or drip any liquids on the appliance or power cord. When liquids are
spilled on the appliance, immediately unplug the appliance and dry it to avoid risk of electric
shock or fire. Do not attempt to operate the appliance, when liquids are on or in the electrical
section of the appliance. Do not clean the appliance in the dishwasher.
1. Remove all promotional materials and packing and place the appliance on a convenient
surface (see: ›Safety instructions‹). Do not remove the rating label.
2. Wipe the heating plates with a damp soft cloth and warm soapy water. Dry it properly after
cleaning.
Note: When using the Design Waffle Maker Pro for the first time, you may notice a fine smoke
haze, because of the first heating of some of the components. There is no need for concern. To
prevent smell and taste of your food from being affected, you should heat the appliance on the
highest temperature control setting without any dough. If the burnt smell occurs again on later
use, clean the appliance (see: ›Care and cleaning‹). If the burnt smell persists stubbornly even
after thoroughly cleaning the appliance, return the appliance to an authorised service centre
for examination and repair.
3. To grease the heating plates, brush the hot grids with a flavourless oil. Then wipe with a
paper towel or pastry brush.
4. Preheat your Design Waffle Maker Pro on the highest temperature control setting, turn on
the appliance and wait round about 8 minutes. The green indicator light will be illuminated
when the appliance is preheated and ready for filling in the dough. Turn the temperature con-
trol to the preferred setting. For best results, do not open waffle maker during cooking process.
use
1. Prepare the dough. You will find a ›Recipes‹ section at the end of this manual.
2. Place the appliance on a well accessible, stable, level, dry, and suitable large table or
counter. Do not place any cloth or tissue beneath or on the appliance, to avoid any risk of fire,
electric shock and overheating. Always keep the table or counter clean and dry and immedi-
ately wipe off spilled liquids. Ensure that there is no foreign substance on the heating plates.
Close the lid.
Do not touch the exterior of the Design Waffle Maker Pro while the appliance is in use. Always
keep your hands, face and arms as well as any clothing and other heat-sensitive objects away
from the waffle maker during operation and only touch the handle, or the temperature control.
Do not touch the heating plates.
Connect the appliance directly to a separately protected mains power supply wall socket with
protective conductor (earth/ground; 220/240 V, 50 Hz, AC, rated for 16 A). The red indica-
tor light will turn on as soon as the plug is connected to the power outlet.
3. Preheat your Design Waffle Maker Pro on the highest temperature control setting. Therefore
turn on the appliance and wait round about 8 minutes. The green indicator light will be illumi-
nated when the appliance is preheated and ready for filling in the dough. Turn the temperature
control to the preferred setting. For best results, do not open the waffle maker during cooking
process. It is important that the heating plates are preheated and greased before the first use.
After finishing the first waffle no more greasing is necessary. To grease brush them with a
flavourless oil. Then wipe with a paper towel or pastry brush.
27