Gastroback 40998 Vital Mixer - Manual (Page 13)

trOuBleShOOtIng
The Vital Mixer is reliable and robust and will work smoothly usually when operated pro-
perly. However, should a problem occur, you will able quite easily to eliminate this in most
cases. The following error table is intended to assist.
warnIng: Do not attempt to use this appliance for any other than the intended use,
described in these instructions. Maintenance and repair of the appliance must be performed
only by an authorized service centre. Do not use the appliance when it is probably dama-
ged or is not working as expected.
problem Solution
The motor starts stuttering or is too slow. Turn to the higher speed level. Pour possibly some of the ingredients from the blender
jug. Pound solid ingredients (e.g.: nuts, hard chocolate) outside of the mixer.
The motor stops during operation or can not
be turned on again. Switch off the appliance immediately (turn the ON/OFF switch to position ›0‹), when
the motor stops unexpectedly or is stuck to prevent overheating. Then, check the
following points:
The motor operates only when the blender jug is properly and fully assembled.
Make sure that the blender jug is properly assembled.
Remove the blender jug from the motor base and clear gently with a wooden or
plastic spoon stuck pieces of food on the blade. Apply no violence not to damage
the blades.
Shred hard ingredients (eg nuts, hard chocolate) outside of the mixer. Remove a part
of the ingredients from the blender jug and then try again with a higher speed level.
ATTENTION: Do not overload the motor of the appliance with too hard or too large
ingredients. Do not over load the blender jug. Process solid ingredients possibly in
several steps. The mixer is not suitable for grating of nuts, chocolate or other hard
ingredients.
The bottom of the blender jug loosens up
during operation; liquid escapes. Switch off the appliance immediately (turn the ON/OFF switch to position ›0‹) and
unplug the power plug from the outlet. Empty the blender jug immediately. Clean and
dry the motor base. If liquids have been spilled into the air vents at the bottom of the
motor base, and have the appliance checked in a specialised service centre.
Make sure that the blender jug is correct and fully assembled according to the instruc-
tions ›Assembling the Blender Jug‹.
TIP: Before filling in the ingredients check the tightness of the mixing jar with some water.
You fail to seal the blender jug; liquid
escapes at the bottom of the blender jar. Empty the blender jug immediately. Disassemble the blender jug and check the parts
for encrustation or damage (cracks, scratches, cracks, deformation). If necessary,
clean these parts.
Replace damaged parts with original spare parts from the manufacturer. Assemble the
blender jug according to the instructions.
ATTENTION: Never operate the appliance with unsuitable or damaged parts. Use only
parts that are intended and approved by the manufacturer for this purpose. To do so,
contact your dealer.
29