beautypg.com

Included content, Installing the engine – Evolution Engines EVOE33GX User Manual

Page 5

background image

EN

5

Throttle

Arm

Rail-mount Installation
1. Remove the 4 screws which attach the

rear-mount.

2. Remove the rear-mount and replace the 4

screws with the shorter M3 screws included
with this engine.

3. Secure the engine mount on the airplane

firewall. Tighten the engine mount screws
in the firewall.

4. Install the engine on the engine mount

according to the airplane manufacturer’s
instructions.

Rear-mount Installation
1. Secure the engine to the airplane firewall

using either M5 or 10-32 bolts. Use spacers
or standoffs as needed to set the correct
firewall-propeller distance according to the
airplane manufacturer’s instructions.

WARNING: Tighten all engine
mounting screws before each flight. If

you do not tighten the engine

mounting screws, the screws may
vibrate loose and cause the engine to
separate from the fuselage.

Included Content

ENGINE
• Muffler (EVOG33601)
• Muffler Screws & Gasket (EVOG33100A)
• Spark Plug (EVOG33350)
• Evolution/Spektrum

Telemetry RPM

Adapter Cable (EVOA107)

• Large Gas-FKM Fuel Tubing (EVOA109)
• Large In-line Fuel Filter (EVOA111)
• Large In-tank Felt Filter/Clunk (EVOA112)

OPTIONAL ITEMS
• Tachometer (HAN156)
• Propeller 17 x 8 (APC17080) for break-in;

18 x 8 (APC18080) for normal flight

• Optical Electronic Ignition Kill Switch

(EVOA100)

• Evolution Synthetic 2-Cycle Oil, (EVOX1001Q)
• Ultra Fuel Pump (HAN155)

Muffler

Spark Plug

Fuel Nipple

High-Speed
Needle

Choke Arm

Low-Speed
Needle

Installing the Engine