beautypg.com

Enabling or disabling battery test, Starting sequence – Evolution Engines EVOE40GX User Manual

Page 9

background image

9

enabling or Disabling battery Test

This ignition makes it possible to enable or disable the battery test. The battery test is very useful when Li-Po or Li-Ion batteries are

used. During the test, a series of flashes are generated and voltage is measured. When the battery passes the test, that means it will

run for a minimum of 10 minutes in flight.

If you want to change the type of silencer, do the first two steps and then continue to PROGRAMMING SEQUENCE. Otherwise, follow

these steps:

BATTERY TEST ENABLED:

- close programming pins with

enclosed jumper

BATTERY TEST DISABLED:

- open programming pins

(remove jumper)

Starting Sequence

- Move propeller to put the piston at bottom dead center of its travel

- Keep your hands outside of the propeller radius to avoid serious injury

- Hold the airplane and switch on ignition

- If battery test is enabled, the ignition starts battery test; during this test, a series of sparks are

generated for about 2 seconds and LED is blinking

- If battery test is disabled, then LED blinks for about 2 seconds

- If LED turns off, you can fly; otherwise battery is low

FIRST STeP

- Screw on pickup on engine
- Attach the plastic protection to the high

voltage cable

- Connect boot to plug
- Mount ground terminal on the high-voltage

cable bolt holding the engine to the motor
mount

- Mount the ignition to the airplane

SeconD STeP

- Connect enclosed LED to the ignition (red or

red/black wire to left)

START

- Keep clear of the propeller
- Connect battery with the ignition box

- Battery test is disabled when jumper is removed and programming

pins are open (this is the default condition of the engine as

shipped from Evolution)

- Battery test is enabled when jumper is plugged and programming

pins are closed

cAuTIon: With the battery test enabled the engine can

unintentionally start during the testing process. Be sure to restrain

the aircraft prior to turning the ignition on when using the battery

test feature.

- Enable or disable battery test when the ignition is off