ETS-Lindgren 95252-1 Bulk Current Injection Probes (Archived) - Manual (Page 20)

Supporting Equipment BULK CURRENT INJECTION PROBES
16 © ETS-Lindgren, L.P. – February 2005
Rev C – PN 399263
SUPPORTING EQUIPMENT
The following equipment is often required when using the
Model 95242-1 to perform susceptibility tests.
Optional Injection Probe
The Model 93686-1 Current Probe with a 6.6 cm window
diameter may be used as a bulk current injection probe over
the frequency range 50 kHz to 2 MHz.
Model 95241-1 Calibration Jig
The Model 95241-1 Calibration Jig is used in equipment
setup for measuring insertion loss of the current injection
probe and is essential to equipment setup of some
susceptibility test procedures.
Current Monitoring Probes
Suggested monitoring current probes are Models 91550-1
(10 kHz to 100 MHz) and 94111-1 (1 MHz to 1 GHz).
Models 91550-1 and 94111-1 have a 1.25 inch (3.2 cm)
window size and a transfer impedance of 0.5 to 6 ohms
over the 50 kHz to 400 MHz frequency range.
Please consult the Sales Department for sizes and
sensitivities of other current probes.
Archived 6/1/10