Eden WT800B - Manual (Page 8)

8
Bridge Mono Output – This is a single NL-4 connector to be used ONLY
in Bridge Mono operation. . The total speaker load impedance should not go
below 4 ohms.
Combination Power Cord Jack and Fuse Holder – The removable power
cord is attached here. To access the fuse holder, pull the holder out of the top
of the power receptacle. Your unit was shipped with a spare fuse inserted in
the fuse carrier. USE ONLY THE SAME SIZE AND TYPE FOR
REPLACMENT. Using a fuse with a different rating than specified is a
VERY BAD THING and can cause damage to your amplifier. All
models come with a holder marked (FUSE) or (115/230) and are factory
configured for 100/120/ 230/240 only and must be adapted by a service tech
for any voltage change.
Fuse Requirements:
USA @ 120 Volts /60 HZ – 10 Amps, 5 x 20 mm GMC/T/slow blow
Europe @ 240 Volts/50 Hz - 5 Amps, 5 x 20 mm GMC/T/slow blow
Japan @ 100 Volts/60 Hz - 12 Amps, 5 x 20 mm GMC/T/slow blow
IMPORTANT NOTE: Always use slow blow or time delay type fuses.
Do not use fast blow fuses.
To convert your amplifier from US to European fusing, remove the Fuse
Holder and insert a 5 Amp slow blow fuse. Flip the fuse holder over and
reinsert.
IMPORTANT NOTE: In order to operate properly in other parts of the
world, your amplifier may require minor modifications. These
modifications must be made by a QUALIFIED technician. Contact your
local distirubtor for further information.
Recording Out (D.I.) – This fully balanced XLR output allows you to send
a pre- or post-EQ signal to a recording or sound reinforcement mixing
console. We use Pin 2 hot configuration. Adjusting the Master Volume
control will not affect this send. This output is designed to use with phantom
powered systems. However, it never hurts to turn off the phantom power at
the board, if possible.