beautypg.com

Eden WT800B User Manual

Page 14

background image

14

Once you have properly set your Input Gain, turn the Master Volume up to a
comfortable listening level and proceed with the rest of the setup process.

Setting the Compressor - If you want to use compression, engage it now by
turning the Compressor Defeat switch OFF. The compressor light will now
blink when your gain goes above the compression threshold. This will
generally show up more on the lower notes, or when you employ Slapping.
(A properly compressed Slap sound is very cool, indeed.) If you want more
compression, increase the Input Gain a little at a time, until you achieve the
amount of compression you desire.

SETTING YOUR EQ

The frequencies that you’ll need to boost or cut are dependent upon your
instrument, playing style, speaker cabinets, and venue. Extreme settings of
boost or cut are unlikely to be necessary or helpful. We are frequently asked
to provide suggested settings for various styles of play. We have discovered
though, that most of our endorsers tend to set their EQ generally flat, using
varying amounts of the Enhance Control to achieve their sound. In fact, a
number of our recording artists tell us that their standard recording set-up is
to have the Enhance set at approximately 9 or 10 O’clock and the tone
controls set flat.

We encourage you to experiment with different settings to obtain the sound
you desire. We have included some EQ panel diagrams at the back of this
manual to help you record your settings.

Enhance – Once you’ve set your gain, you can move on to setting your EQ,
beginning with the Enhance control, or Magic Knob, as some call it. The
Enhance circuitry adds very low bass, upper mids and highs while scooping
out a bit of low middle. The more Enhance effect you dial in, the greater the
boost (and cut). As with all of our EQ controls, a little goes a long way.

Slowly bring the Enhance control up while playing. If you turn it up close to
12:00 on the dial and still don’t have your sound, stop there. Return the
Enhance to OFF or leave it at no more than 12:00 and work with the EQ
section.

Using the EQ Controls – Before you begin to twiddle knobs, let’s talk
about a few things. Excessive boosting of one or more EQ frequencies may
cause an overload in the EQ section. If this happens, the EQ Clip light will
engage. This is a Very Bad Thing and needs to be corrected immediately.