Eden WT405 - Manual (Page 7)

7
We recommend you engage these switches at low volumes so that your
sound remains consistent at any volume. At higher volume levels they aren’t
needed but you may want to use them as a matter of taste. Because we
strongly support Freedom of Choice, we’ve incorporated these two switches
into our design. (You’re welcome.)
Master Level Control – Adjusts overall system output and stage loudness.
Headphone Jack – Accepts a standard _ inch stereo or mono headphone
plug. It can also be used as a Master Output send to slave another amplifier.
Output Limit Indicator – Lights to indicate activity of the power amplifier
limiting circuit, which protects the speaker system from severe distortion.
This LED indicates that the amplifier has reached its maximum output level.
Mains On/Off Switch – This switch turns the system power ON or OFF.
The switch illuminates to indicate the presence of AC power present in the
chassis. This switch is prior to the fuse. The switch light can be on even if
the fuse is blown. The light in the switch may flicker depending on local
voltage conditions. This is normal and nothing to be concerned about.
Speaker On/Off Switch – This switch turns off the loudspeaker output
jacks allowing the user to use the headphones only for silent practice. Room
mates and neighbors may really appreciate this feature, especially at three in
the morning.
REAR PANEL FEATURES
Combination Power Cord Jack and Fuse Holder – The removable power
cord is attached here. To access the fuse holder, pull the holder out of the top
of the power receptacle. Your unit was shipped with a spare fuse inserted in
the fuse carrier. USE ONLY THE SAME SIZE AND TYPE FOR
REPLACMENT. Using a fuse with a different rating than specified is a
VERY BAD THING and can cause damage to your amplifier. All
models come with a holder marked (FUSE) and are factory configured for
100/120/ 230/240 only and must be adapted by a service tech for any voltage
change. The standard fuse for U.S. use is a 5 Amp slow blow or time delay
type. Do not use fast blow fuses.