Eden WT405 - Manual (Page 5)

5
FRONT PANEL FEATURES
Input Jacks – Designed to accept a standard _ inch mono phone plug. For
best results use a high quality shielded cable to connect your instrument to
the amplifier. Both inputs are buffered and will handle standard passive,
high level active, and piezo input signals. Both jacks can be used
simultaneously.
Mute switch – Mutes all the outputs except the Tuner Out, allowing for
silent tuning. Lead singers and guitarists love this feature! The indicator
lights when Mute is ON.
D.I. Selector – Allows the user to send the D.I. before (PRE position) or
after (POST position) the Tone Control section.
Input Gain Switch – By pushing the Gain Switch in, you engage a +10db
gain boost. For low gain instruments use the High Gain position.
Hi Gain Indicator LED – Lights to indicate that the unit is in the high gain
position.
Warm Switch – This switch engages the positive half-wave tube-style
warmth circuit, which is part of what the Golden Ear Chip is there for. The
warmth/grit effect is increased by adding more input gain.
Warm Trim – Located behind the front panel. Use a small screwdriver to
adjust the level of the effect.
Gain Control – Regulates the first gain stage of the preamplifier and
controls the amount of signal available to the system.
Clip Indicator – Flashes to indicate clipping anywhere in the system.
Clipping is a Very Bad Thing and will degrade the quality of your sound.
Therefore, this indicator should never be lit up.
Compressor Control – This adjusts the threshold level of the compressor.
The ratio is fixed at an optimum point for Bass reproduction.
Compressor Indicator – Lights to indicate that the signal has crossed the
threshold of the compression circuit and that compression is taking place.