Quality certification, Copyright, The symbol ce – Dyras HSTR-016CR User Manual

Page 5: Maintenance and cleaning

HSTR-016CR

QUALITY CERTIFICATION

It is hereby certified that the mini ceramic coated hair styler, type dyras HSTR-016CR with car plug, conforms to
the following technical specification:

Type:

HSTR-016CR

Description:

mini ceramic coated hair styler with car plug

Rated supply:

12V DC

Rated current:

4.5A

We are continuously developing our products to keep them up-to-date, which means the technical data of our appliances may change without
any prior notice. Errors and omissions excepted.

COPYRIGHT

All rights - including distribution by film, radio or television, translation, photographic or audio copying, abstract
reprint and other duplication - are specifically reserved. Any breach may result in legal action.

THE SYMBOL CE

This appliance meets the requirements for safety and electromagnetic compatibility (EMC). The relevant ‘CE’ mark
can be found on the nameplate, on the packing box and in the instruction manual.

3. When you have finished hair styling, turn the stylers off using the ON-OFF button (4), then unplug them

from the power supply. Place the stylers on a heat resistant surface until they have completely cooled down.
Ensure there are no flammable substances nearby, do not to touch the styling plates.

Practical advice for hair styling

Straight hair: put a section of hair around 4cm-5cm wide between the styling plates. Close the appliance, move

it slowly from the root of the hair to the ends, then open it. Allow between 5 and 8 seconds for straightening
thinner hair; thicker hair will take 10-15 seconds.

Softly twisting locks of hair: put a section of hair around 4cm-5cm wide between the styling plates. Follow the

advice above but also turn the appliance while moving it through your hair.

Outward ‘flicks’: put a section of hair between the styling plates, keeping the plates as near the roots as

possible. Grip the hair and move the appliance from the root of the hair to the ends, turning the styling plates
outwards as you reach the ends.

Inward, folded-back ‘flicks’: put a section of hair between the styling plates, keeping the plates as near the

roots as possible. Grip the hair and move the appliance from the root of the hair to the ends, turning the
styling plates inward as you reach the ends.

Do not brush or comb your hair immediately after styling.
Wait until your hair cools down, otherwise the styling effect will be reduced or lost.

MAINTENANCE AND CLEANING

Warning! Always unplug the device before cleaning. Wait until the stylers have completely cooled
down before beginning cleaning. Never plunge the stylers into water or put them under running
water!

•

To clean the handle, wipe it with a soft cloth that’s been moistened with a few drops of mild detergent. Next,
remove the detergent by wiping with a soft lint-free cloth moistened with lukewarm water. Finally, wipe the
cleaned surfaces with a dry lint-free cloth. Take care to ensure no moisture enters the appliance. Make sure
the hair straighteners are completely dry before using them again.

•

Never use solvents (acetone, benzene, petrol etc.) to clean the appliance because these materials could
dissolve the plastic cover and damage the internal components. Do not use harsh or abrasive cleaning agents.

•

Never scrub or scour the styling plates; this can damage the glossy surface. Any dirt should be removed with a
soft lint-free cloth.

•

If you do not want to use the stylers for a long time after cleaning, put them in a nylon bag and store them
in a frost-free environment that is free from humidity and dust. The power cable should not be wound
around the stylers, even not for storage purposes, as this may result in damage to or weakening of the cable
insulation.

User's Manual for HSTR-016CR_5L.indd 8-9

2011.02.04. 23:27:45