Dyras ESI-3000LC - Manual (Page 8)

EN
ESI-3000LC ESI-3000LC
14 15
Cleaning the body of the iron
1. Clean the outside cover of the appliance with a damp, soft, lint-free cloth and then wipe the cleaned
surfaces with a dry lint-free cloth. Take care not to allow any moisture inside the cover. Let the appliance dry
completely before re-using or storing it.
2. When cleaning the appliance, never use solvent (acetone, benzole, petrol, alcohol, etc.) as these may solve the
casing material, or the internal parts of the appliance if they get into. Do not use cleaning agents with coarse
or grinding effect.
3. Before storing the iron, empty the water tank and leave the fill/drain cover open until the tank is completely
dry. Any moisture could cause mould.
4. Never remove the casing or dismantle the iron.
5. The iron should only be packed away for storage when it is completely cool and has been cleaned. If you do
not plan to use the appliance for a while, put it in a plastic bag and store it in a dry, dust-free and frost-free
place. Never leave any water in the tank.
trouble
Material gets shiny under the
soleplate, or the fibres get shrunk or
scorched.
No steam or water leaks from the
equipment.
No or not sufficient steam production.
Water drops come out of the iron
soleplate.
Little steam that flows out of the
apertures unevenly.
No water spray
possible reason
Soleplate temperature is set too high
You held the water tank in an
imporper position while filling it up.
Too low iron soleplate
Check if steam control slide button is
closed or not.
No or too little water in the water
tank.
The equipmentis not heated up yet
properly.
You use extra steam impulse button
too often.
Too much water filled in.
Steam apertures or tank is clogged.
Too little water in the tank.
Not sufficient pressure or air.
No or little water.
trobleshooting
Select the setting according to the
material type. In the case of mixed-
fibre textile, set the material type to
be ironed at the lower temperature.
Fill it up again according to the water
fill-up instruction.
Steaming is only possible if WOOL,
COTTON and LINEN is set, in these
cases a steam cloud icon indicates
that the function is available.
Slide steam control button to the
direction of greater-steam volume
marking.
Fill the water tank
Operate extra steam impulse function
only when heating status indication
light has already gone out.
Use extra steam impulse function
maximum three times between two
heat-ups, and keep longer breaks
between uses.
Pour out unnecessary water until
reaching “MAX” marking on the water
tank.
Apply self-cleaning function of the
equipment – if you have to use
this function very often, start using
distilled water.
Fill water into the tank.
Press (keep closed) the water spray
head with your hand,
and press water spray button repeat-
edly several times.
Fill water into the tank.