Dyras CH-7515 - Manual (Page 6)

CH-7515
10
EN
CH-7515
11
QUALITY CERTIFICATION
It is hereby certified that heat radiator with ceramic insert, type dyras CH-7515 meets the technical parameters
below:
Type: CH-7515
Name: Heat radiator with ceramic insert
Nominal mains voltage: 220-240 V ~ 50 Hz
Nominal power consumption: 1500 W
Noise emission: L
WA
= 55 dB
Contact protection class: II.
Manufacturer: The dyras www.factory, Inc. U.S.A.
We are continuously developing our products to keep them up-to-date, which means the technical data of our appliances may change without
any prior notice. Errors and omissions excepted.
COPYRIGHT
© Copyright The dyras wwe.factory LLC U.S.A.
All rights - including distribution by film, radio or television, translation, photographic or audio copying, abstract
reprint and other duplication - are specifically reserved. Any breach may result in legal action.
THE SYMBOL CE
This appliance meets the requirements for safety and electromagnetic compatibility (EMC). The relevant ‘CE’ mark
can be found on the nameplate, on the packing box and in the instruction manual.
• If the room temperature drops back below the temperature dial’s set point, the heater will switch on again to
maintain the setpoint value and ensure the comfort of the room’s occupants.
• You can change the temperature dial’s set point during use as you wish.
The device is supplied with double protection to prevent possible over-heating and ensure security for life and
property. Should the device stop during operation for any reason other than exceeding the temperature dial’s
set point value, please switch it off, then withdraw the mains connector from the wall socket or extension.
After 30 minutes of cooling time, attempt to use it again. Meanwhile, check that the device is not covered with
anything and has not capsized. Should the device fail to operate after this outage, or it stops again, switch it off
immediately and withdraw the mains cable connector from the wall socket. Then, when the device has cooled
down, take it to an authorized professional service centre for repair.
MAINTENANCE AND CLEANING
Warning! Before you clean the appliance it must be switched off and the mains plug must be
removed from the wall socket.
Wait until the appliance has cooled down completely before you start cleaning it.
• Clean the outside cover of the appliance with a damp, soft, lint-free cloth and then wipe the cleaned
surfaces with a dry lint-free cloth. Take care not to allow any moisture inside the cover. Let the appliance dry
completely before re-using or storing it.
• Please remove any contamination lodged in the grids of the air inlet and air outlet openings.
• When cleaning the appliance, never use solvent (acetone, benzole, petrol, alcohol, etc.) as these may solve
the casing material, or the internal parts of the appliance if they get into. Do not use cleaning agents with
coarse or grinding effect.
• The appliance should only be packed away for storage if it has cooled down completely.
• If you do not wish to use the appliance for a while, put it in a plastic bag and store it in a dry, dust-free, frost-
free place.
User'sManual for CH-7515.indd 10-11 User'sManual for CH-7515.indd 10-11 2011.06.29. 18:30:33 2011.06.29. 18:30:33