Cwtx-1512 – Dyras CWTX-1512 User Manual
Page 4

CWTX-1512
6
EN
CWTX-1512
7
•
Never lay the mains cable beside or across sharp edges or hot surfaces. Never wrap the mains cable around
the cover of the appliance, do not pull the cable and do not lift the appliance with the mains cable because
the cable can break or the insulation can be damaged. A damaged cable must be replaced by an authorised
service engineer. The appliance must not be used or connected to a wall socket if the cable is damaged.
•
Only use the appliance on a stable, level surface. Keep it away from water and make sure it cannot
accidentally slip or fall. If the appliance comes into contact with any kind of moisture or liquid during use,
immediately unplug it from the mains. Do not touch it or attempt to take it out of the liquid until the mains
plug has been removed from the socket. You must not use the appliance again before having it checked and
repaired by a specialist engineer.
•
You must not disassemble the appliance, remove its cover or to try to repair it. Ignoring this advice could
cause a serious accident. There are no parts in the appliance that can be repaired at home or used for any
other purpose. Never operate the appliance with a damaged mains cable or connector. Do not use the
appliance if it fails to work normally or if it has been dropped or damaged. If the appliance becomes faulty
for any reason or if any moisture is allowed inside, take it to an authorised service engineer for checking
and repair. Only service engineers who have been trained and approved should repair the appliance. The
manufacturer cannot take any responsibility for unauthorised repairs or for any circumstances resulting from
not following the instructions.
Attention!
Never leave the appliance connected to the mains when it is unattended.
Modifying or adding an extra length to the power cable of the appliance is forbidden!
Should the cable of the appliance turn out to be too short, it may be extended only by using a
commercially available standard extension cable equipped with protective earth contact, and the
extension cable must have an electrical rating of at least 16 A (cables with lower electrical rating
could heat up during use). If other electric appliances have to be operated simultaneously with the
same extension cable, their current consumptions must be added up to determine the electrical
rating requirement of the extension cable. If an extension cable is used, both the mains socket
and the extension cable must have protective earth. When an extension cable is used, special care
must be taken to avoid tripping over it.
•
Do not allow anything to be dropped into the slots of the water heater or the power supply foot and never
insert anything.
•
To avoid overloading your electricity supply, please don’t use the appliance at the same time as any other
high-power device (e.g. a kettle or heater) in the same socket or on the same mains circuit.
•
Always take care to avoid straining the electric cable, never drag or lift the appliance by the power cable as
it could be torn off or damaged. For the same reason prevent the power cable from getting under the feet of
chairs or other furniture.
•
When you have finished using the appliance, always switch it off and remove the mains plug from the wall
socket or extension cable.
•
Put the appliance onto a flat, stable surface, where the water heater will not be overturned, dragged down or
fall and is safe from children, even after use.
•
During use the cover of the appliance will be hot. Take care not to touch the hot part of the cover as there is a
risk of burning; hold the appliance only by the handle and be extremely careful when pouring hot water.
•
The appliance can only be used for boiling water; no other substance can be boiled in the tank. The appliance
is not intended for boiling milk. It is strictly prohibited to put food into the water boiling in the appliance
(sausages, instant soup, tea in the filter etc.)!
•
Only fill the tank with cold water. Fill to between the minimum and maximum level marks. Over-filling the
tank can allow water to spill causing injuries. The kettle can only be switched on when the tank cover is shut.
The cover cannot be opened while the water is boiling.
•
Do not move the appliance during operation. After using it turn it off, or wait for the automatic
shutdown, then unplug the appliance from the socket and wait until it is completely cooled down before
packing it away.
•
The power supply foot must only be used with the kettle. If the power supply foot is damaged, impaired or
immersed in water, stop using the device immediately. In such cases contact your dealer or authorised service
agent to have the device inspected or repaired.
•
The kettle must only be filled up, emptied or cleaned when removed from its power supply foot. Before
removing or returning the kettle to its power supply foot, ensure the main switch is off.
•
Should the power supply foot get wet, immediately remove the plug from the socket, then wipe the power
supply foot dry. Do not turn on the appliance unless the power supply foot is completely dry.
•
The kettle has a safety cut out, protecting it against damage caused by use without enough water which can
result in the heater coil overheating. Should the safety cut out initiate from a lower water level than the
minimum required or being switched on without water, the appliance must be removed from the mains,
then after a period of cooling down (min. 30 minutes) the appliance can be used again. If, after this period,
the appliance does not switch on, contact your dealer or authorised service shop to have the appliance
repaired. Use without water or with a lower water level than the minimum required will qualify as improper
use and the manufacturer’s warranty will lose its validity for the damage caused.
Warning!
When filling or rinsing out the tank of the appliance, never put it under a tap or
submerge it into water!
•
Never remove the water heater from its power supply foot if the pilot-light is lit (when the appliance is not
shut down automatically or by hand) - as an electric arc can be produced at the power supply contacts which
may result in damage to the appliance.
7
6
User'sManual for CWTX-1512.indd 6-7
User'sManual for CWTX-1512.indd 6-7
2010.12.10. 17:27:46
2010.12.10. 17:27:46
Process Black
Process Black