Harbor Freight Tools Model 2439 - Manual (Page 4)

Page 4
SKU 2439
.
Operation
For best service you should incorporate an oiler, regulator, and inline filter, as shown in the
diagram above. Hoses, couplers, oilers, regulators, and filters are all available at Harbor
Freight Tools.
1. You will need to prepare a 1/4” air connector (sold separately) to connect to the
Air Inlet (12) on the Angle Drill. First, wrap the 1/4” air connector (not included) with pipe
thread seal tape before connecting to a 3/8” ID Air Source Hose (not included). Connect the
Air Source Hose to the Angle Drill.
Note: If you are not using an automatic oiler system, before operation, add a few drops of
Pnuematic Tool Oil to the airline connection. Add a few drops more after each hour of continual
use.
2. Set the air pressure on your compressor to 90 PSI. Do not exceed the maximum air pres-
sure of 90 PSI.
3. Check the air connection for leaks.
Warning: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It must be
understood by the operator that common sense and caution are factors which cannot
be built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure the parts listed on page 6 are included. If any parts
are missing or broken, please call Harbor Freight Tools at the number on the cover of this
manual as soon as possible
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities, contain chemicals known [to the State of California]
to cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
- Lead from lead-based paints
- Crystalline silica from bricks and cement or other masonry products
- Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type
of work. To reduce your exposure to these chemicals: work in a well ventilated
area, and work with approved safety equipment, such as those dust masks that are
specially designed to filter out microscopic particles.
(California Health & Safety Code § 25249.5, et seq. )
Warning! Operation of equipment in close proximity to a heart
pacemaker could cause interference or failure of the pacemaker.
Angle
Drill
1/4” - 18 NPT