CDI Torque TORQUE WRENCHES Dial Type - Manual (Page 8)

Page 5
Scale Pointer
To repair loose scale pointer if removed from the
post.
1.) Take the scale pointer (orange) and align it to the
center of the square drive of the wrench.
2.) Place it in the center post in the center of the
scale.
3.) Align the scale pointer end point to the center of
the drive end of the wrench.
4.) Press into place.
5.) Tap it lightly to lock it into place with the
handle end of a plastic screwdriver or other
instrument. This will lock it into post.
The scale pointer (orange) end is slightly bent
upwards to allow the memory pointer (blue) to be
pushed by the scale pointer. If the scale pointer
(orange) end is not bent upwards or the scale
pointer (orange) end is touching the scale plate it
must be bent or replaced.
Scale with Electric Signal
To repair a wrench if the signal is not working on the wrench:
1.) Check/replace the battery first.
2.) Next, check the light bulb to assure it is screwed in and making contact.
3.) Remove the lens and remove the scale pointer (orange) from the wrench. Take a knife
and scrape the sides of the pointer (to assure better contact).
4.) Clean the contact on the scale.
5.) Check the wiring for broken wires or damaged wires.
6.) If the buzzer doesn’t work check the wiring connection to the battery.
If none of these remedies correct the problem, contact CDI Service Department, to return
the wrench to CDI for repair.