Craftsman 315.21234 - Manual (Page 17)

16 17
Fig. 12
SAW VIEWED FROM BOTTOM
MITER
SAW BASE
TABLE
EXTENSION
ASSEMBLY
TABLE EXTENSIONS
See Figures 12 - 13.
If you plan to use the stop block, slide the stop block on
the back arm of the desired table extension first.
To install table extensions, insert the ends of extensions
into the holes in the sides of the base. Adjust the exten-
sions to the desired length.
Secure them in place by positioning a clamp bracket un-
der each table extension beneath the miter table. Orient
each clamp bracket as shown in figure 13.
Secure each clamp bracket in place with a clamp bracket
screw. The clamp bracket screw threads through the
clamp bracket and tightens against bracket support on
bottom of miter table, securing clamp bracket against
table extension.
WARNING: When using the work clamp with the
stop block, install the clamp on the same side as the
stop block. This will eliminate the possibility of trap-
ping the workpiece, resulting in the saw blade and
workpiece kicking up. Failure to heed this warning
can result in serious personal injury.
TABLE
EXTENSION
MITER
SAW BASE
BRACKET
SUPPORT
CLAMP
BRACKET SCREW
CLAMP
BRACKET
TABLE
EXTENSION
Fig. 13