Boori Baby to Youth Cot bed BO-B2Y - Manual (Page 5)

Baby to Youth COT assembly instructions
6
7
Lowering base into cot
NOTE: Make sure base is facing up.
Lower the base into the cot and
place onto base supports making
sure the base is facing up.
Screw onto base supports using
4 x E bolts.
To operate drop side panel
8
Newborn position
The base should be
lowered to the baby
position before the
child can sit up
Baby position
Unscrew
4 x E bolts
from base
supports and
lift out base.
A B
Unscrew
8 x C bolts
from lower
base holes.
C
Move base supports
to lower level and
lower base onto
base supports.
D E
Re-use 4 x E
bolts to screw
base to base
supports.
Re-use 8 x C
bolts to cover
remaining
base holes.
Lowering the base height for baby position
TO LOWER THE DROP SIDE PANEL pull the drop side
up to the highest position. Hold it in that position
while using your leg to push (at the centre bottom
bar) inward. Then allow the drop side panel to slide
down. To raise the drop side panel, pull the drop
side panel up from the centre of top bar until it
clicks into the locking position.
V 07/06