Boori Baby to Youth Cot bed BO-B2Y - Manual (Page 4)

3 Attaching the fixed side
4
Placing base supports for newborn & baby positions
NOTE: Please place base supports on to end panels with pin facing up
for base to sit on.
Place 4 x base supports, must
have pin facing up.
Base at newborn position.
Screw 4 x Base supports to
end panel with 8 x C bolts.
Screw 8 x C bolts
to cover remaining
base holes.
Base at baby position.
This height should be used when
your baby can sit up. Screw 4 x
Base supports to end panel with
8 x C bolts.
Screw 8 x C bolts
to cover remaining
base holes.
Connect the fixed side panel to the end panels
using 4 x I bolts.
(DO NOT over tighten at this stage)
5
A: Screw 4 x A
drop side glide
pins firmly into the
end panels using
a Philips head
screwdriver.
(not supplied)
A
B
B: Push end panels
outward to allow
space for the assembly
of drop side panel.
Allow glide pins of one
end panel to attach
into the runner on drop
side first, then allow the
pins on the other side
to slide into runner and
pull both end panels
inward. Tighten all bolts
in fixed side panel.
C
Newborn position
Baby position
Attaching the fixed side
requires two people as
end panels will not
free stand.
Attaching the drop side
C: Fully screw in
blocking bolts on
both end bars of drop
side panel.
Baby to Youth COT assembly instructions
V 07/06