AZZA Toledo 301 - Manual (Page 7)

INSTALLATION INSTRUCTION
1_Open The Side Panel
2_Remove The Front Panel and Top Panel
3_Install Power Supply
1.Remove the locking screws on left hand side of the case towards the back of the case.
2.Slide out the side panel.
1.Hold the front panel by placing one hand on top of the case and one hand at the
bottom.
2.Pull the bottom part front panel towards you.
1.Remove the screws which locked the top panel from inside the case with a screwdriver.
2.Hold the top panel with both hands and push toward you.
3.Then take off the top panel.
1.Place the power supply towards the bottom of the case.
2.Tighten the power supply with screw.
3.This case is designed in a way that the power supply unit can be installed either facing
up or down.