AZZA GT 1 - Manual (Page 8)

6.Motherboard Tray Removal and Installation
7.Power Supply Installation
6.1 Unscrew the thumb screws on the rear and the side of the motherboard
6.2 Pull the motherboard tray out of the chassis
6.3 Rotate the motherboard tray 180 degrees
6.4 Gently slide the motherboard tray back into the chassis
6.5 Secure the motherboard tray with the provided screws
* To provide better cooling performance, the suggested orientation of the graphics
card is at the top of the case. The motherboard tray can be rotated 180 degrees
to revert to the standard AXT form factor.
7.1 Rear power supply installation
7.2 Place the power supply into its proper location and
tighten the screws
8.Motherboard, CPU and Graphics Card Installation
8.1 Unscrew the thumb screw and pull out the motherboard tray from chassis
8.2 Lay the motherboard tray on a flat surface
8.3 Install the I/0 shield that comes with your motherboard package
8.4 Secure the motherboard to the standoffs on the motherboard tray
8.5 Install the graphics card on the motherboard and secure the graphics card to the expansion slot with
the provided thumb screw