Appendices, Replacing the lamp – Compaq EP7150 User Manual
Page 32
32
English
Appendices
Replacing the Lamp
The projector keeps track of the lamp usage. It will show you a
warning message
When you see this message, change the lamp as soon as pos-
sible. Make sure the projector has cooled down for at least 30
minutes before changing the lamp.
Warning: Lamp
compartment is hot!
Allow 30 minutes
to cool down before
changing lamp!
Warning: To
reduce the risk of
personal injury, do not
drop the lamp module
or touch the lamp bulb.
The bulb may shatter
and cause injury if it is
dropped.
Lamp Replacement Procedure:
1. Switch off the power to the projector by pressing the Power
button.
2. Allow the projector to cool down for at least 30 minutes.
3. Disconnect the power cord.
4. Use a screwdriver to remove the screws from the cover.
5. Push up and remove the cover.
6. Remove the 2 screws from the lamp module.
7. Pull out the lamp module.
To replace the lamp module, reverse the previous steps.
2
4
1
3