Alumax 890c User Manual
Page 6
EPH-N00-06083
6-3-02
Page 6 of 8
6
Measure the horizontal frame opening at the top
and bottom. The minimum dimension for the door
opening is the glazed door panel width [J] plus 1/2",
maximum is the door panel width plus 1 3/4".
Using the holes in the ends of the curb [A] and header
[B] as a guide, drill four 1/8" holes into the wall jambs
[C]. Secure the header and the curb to the wall jambs
with four #8 x 1/4" truss head screws [L].
Snap the vinyl upper steam seal [K] into the top
rail of the door panel with the sealing flap to the interior
(flat) side.
Snap the fillers [N] into the curb [A] and header [B]
between the door jambs with the raised lip to the
exterior. Center the curb filler in the curb between the
pivot and strike jamb (use masking tape to hold it in
position).
NOTE: The snap-in fillers should be exactly 3/8" longer
than the door panel width.
8
7
Press the glazed door panel assembly [J] and
strike jamb [M] (with magnetic strip) over the wall
jambs.
NOTE: The magnetic strip on the strike jamb must face
the exterior and the door panel must open outward.
EXTERIOR