Alumax 650D - Manual (Page 7)

Page 7 G03920296
8-13-09
Locate the bottom guide [P] in the middle of the
tub track [A]. With a 7/64” bit, drill two holes into the
v-groove through the mounting holes in the guide. Install
the bottom guide with two #6 x 3/8” truss head screws
[Q] through the drilled holes as shown.
Caulk both ends of the tub track [A] where it
meets the wall jambs [B] and the interior edge of the
wall jambs as shown. Run a bead of caulking along the
interior of the tub track.
NOTE: We recommend that you let the caulk cure for 24
hours before you use your new enclosure.
10
11
The Care and Cleaning of your new A
LUMAX
Bath Enclosure. The simplest and preferred
method of cleaning your unit is by washing it with clean water and drying with a soft cloth.
If soil is still present after drying, a non-abrasive cleanser with a pH of seven to eight may
be used. Comet Bathroom Cleaner
® has been tested and is recommended by the Bath
Enclosure Manufacturers Association (BEMA). Do not use scouring pads, sharp instruments,
or acid-based cleansers to clean the unit.
Thank you for choosing an A
LUMAX
Bath Enclosure. Please take a moment to complete
and return the enclosed Customer Response Card. The information you provide helps us
improve the quality of our products and provide better service to you, our customer.