Alumax 392 - Manual (Page 11)

EPH-N00-06010
5-20-97
Page 11 of 11
22
Cut four pieces of the larger vinyl [KK] 1/2"
longer than the horizontal opening and trim the
ends on a 45° angle. Install the top exterior vinyl
starting at both ends and working toward the
middle. Be careful not to stretch the vinyl.
Install the top interior vinyl and the two bottom
vinyls in the same way.
23
Carefully caulk the interior jamb-to-wall
and curb-to-base joints. For appearance, you may
wish to caulk the exterior joints as well. We
recommend you wait twenty-four hours before the
first shower to allow the caulking to cure properly.
The Care and Cleaning of your new A
LUMAX
Bath Enclosure. The simplest
and preferred method of cleaning your unit is by washing it with clean water and
drying with a soft cloth. If soil is still present after drying, a non-abrasive cleanser
with a Ph of seven to eight may be used. A glass cleaner without ammonia is
recommended. Do not use scouring pads, sharp instruments, or acid-based
cleansers to clean the unit.
Thank you for choosing an A
LUMAX
Bath Enclosure. Please take a moment
to complete and return the enclosed Customer Response Card. The information
you provide helps us improve the quality of our products and provide better service
to you, our customer.