Acolyte RibbonLyte in Screwed-In Channel - Manual (Page 4)

All artwork and images copyright Acolyte Industries Inc.
Use or reprinting prohibited unless explicitly approved by Acolyte Industries.
I N S TA L L AT I O N - - S T E P S 5 - 8
5
7
6
8
PA G E 3
After surface is dry, apply 1/16” double-sided
tape (E) to the desired mounting path of the
RibbonLyte inside your channel.
(E)
Remove backing from double-sided tape
(E).
(E)
Remove the backing from the RibbonLyte
(F) that you are going to be applying atop
the double-sided tape.
(F)
Apply the RibbonLyte (F) by placing one
end of the strip at the end of the double-
sided tape (E) inside the channel (C) then
slide your finger along the RibbonLyte (F) to
make sure there is firm contact and that the
tape adheres well.
(F)
(E)
(A)