Acolyte RibbonLyte in Channel with Slide-In Stand - Manual (Page 3)

All artwork and images copyright Acolyte Industries Inc.
Use or reprinting prohibited unless explicitly approved by Acolyte Industries.
I N S TA L L AT I O N - - S T E P S 1 - 4
1
3
2
4
Space your tiltable stands every meter and
make marks where the holes in the stand are
to mark your screw locations. If the channel
length is shorter than 1 meter, use two
tiltable stands placed several inches from
the end of edge of the channel.
Screw the Slide-In Tilt Stand (A) into place
using the appropriate screws (B).
Drill a pilot hole for the mounting clip screws
at each of the marks you have made along
the mounting path.
Slide Channel (C) into Slide-In Tilt Stands
(A) so that the channel is held in place.
PA G E 2
(A)
(C)
(A)
(B)