Connecting the drain line, O note – LG WT4970CW User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION INSTRUCTIONS
15
Connecting the drain line
Secure the drain hose in place to prevent moving and leaking.
O NOTE-----------------------------------------------
The drain hose should be properly secured. Failure to
properly secure the drain hose can result in flooding
and malfunction.
Total height of the house end should not exceed 96
inches (244.8 cm) from the bottom of the washer.
The drain must be installed in accordance with any
applicable local codes and regulations.
Make sure that the water lines are not stretched,
pinched, crushed, or kinked.
Using a standpipe
1 Insert the end of the drain hose into the standpipe.
Using a laundry tub
1
Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches (10 cm) from the
end of the drain hose. If the drain hose is extended more than
4 inches (10 cm) beyond the end of the elbow bracket, mold,
or microorganisms could spread to the inside of the washer.
No more than
4 inches (10 cm)
2
Hang the end of the drain hose over the side of the laundry tub.
3
Use a tie strap to secure the drain hose in place.
2 Use a tie strap to secure the drain hose in place.
Cable Tie