Cadet CEH-005M User Manual
Owner’s guide, The ceh industrial unit heater, Features & benefits
IMPORTANT INSTRUCTIONS
OWNER’S GUIDE
The CEH Industrial Unit Heater
Features & Benefits
•
Commercial grade high temperature
manual reset
•
High mass, tubular element for longer life
•
Fan delay eliminates cold draft on startup
and disperses residual heat on shutdown
•
Rugged die formed construction for durability
•
Wire single or three phase to suit the application
•
Vertical or horizontal delivery
•
5 Year Warranty
Model: CEH005P
Recommended for elevations under 7500 feet
TOOLS REQUIRED:
•
Appropriate Fasteners
•
Straight Screwdriver
•
Crescent Wrench
•
Wire Strippers
•
Strain Relief Connector
•
Phillips Screwdriver
WARNING
Turn the electrical power off at the electrical panel board (circuit breaker or fuse box) and lock
or tag the panel board door to prevent someone from turning on power while you are working
on the heater. Failure to do so could result in serious electrical shock, burns, or possible death.
1. Read all instructions before installing or using this heater.
2. Read all information labels. Verify that the electrical supply
wires are the same voltage as the heater.
3. All electrical work and materials must comply with the
National Electric Code (NEC), the Occupational Safety and
Health Act (OSHA), and all state and local codes.
4. Connect the grounding screw provided in the wall can
to the supply ground wire.
5. If you need to install a new circuit or need additional wiring
information, consult a qualified electrician.
6. Protect electrical supply from kinks, sharp objects, oil,
grease, hot surfaces or chemicals.
7.
WARNING
Overheating or fire may occur. DO NOT install the heater
in a floor, in the ceiling, below a towel bar, behind a door, or
anywhere the air discharge may be blocked in any manner.
8.
WARNING
Fire or explosion may occur. DO NOT install heater in any
area where combustible vapors, gases, gasoline, liquids, or
excessive lint or dust are present. A heater has hot and arcing
or sparking parts inside.
9.
WARNING
DO NOT install where heater is likely to get wet. Do not
use outdoors.
SAVE THESE INSTRUCTIONS
www.cadetco.com Tel: 360-693-2505 P.O. Box 1675 Vancouver, WA 98668-1675
1
10.
WARNING
Burn Hazard. This heater is hot when in use. To avoid burns,
do not let bare skin touch hot surfaces. Use extreme caution
when any heater is used by or near children or invalids, and
whenever the heater is left operating and unattended.
11.
WARNING
Risk of Electrical Shock. DO NOT install the heater directly
above bathtub or sink. DO NOT install in shower stall area
(Manufacturer recommends a minimum 2 foot clearance).
12.
WARNING
Risk of Electrical Shock. Connect grounding lead to grounding
screw provided. Keep all foreign objects out of heater.
13.
WARNING
Risk of Electrical Shock. Never place a switch where it can
be reached from the tub or shower enclosure.
14.
WARNING
Risk of Fire. Do not block heater. Heater must be kept clear of
all obstructions: Keep combustible materials, such as furniture,
pillows, bedding, papers, clothes, etc. and curtains at least 3 feet
from the front of the heater and 6 inches above and on both sides.
15.
WARNING
Risk of Electrical Shock. Do not operate any heater after it
malfunctions. Disconnect power at service panel and have
heater inspected by a reputable electrician before reusing.
16.
WARNING
Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause fire, electric
shock, or injury to persons.