Craftsman 152.213351 - Manual (Page 10)

A
warning Fig. 6
1. DO NOT assemble the Dust Collector until you are
sure the tool IS NOT plugged in.
2. DO NOT assemble the Dust Collector until you are
sure the power switch is in the "OFF" position.
2. For your own safety, DO NOT connect the machine
to the power source until the machine is completely
assembled and you read and understand the entire
Owner's Manual.
SWIVEL CASTER TO
BASE ASSEMBLY
A
warning
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
1. Place the dust collector on its side.
3. Place 3/8-16 flange hex nut (C) onto bolt (D) of swivel
caster and tighten. See figure 6.
4. Repeat Steps 2, 3 and 4 above to assemble the
remaining swivel caster assemblies to base.
Fig. 5
2
.
Insert bolt on the swivel caster assembly through
each one of the four holes (A), in the base of the
dust collector. See figure 5.
EXHAUST FLANGE ASSEMBLY
A
warning
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
1. Align the holes in the exhaust flange (A) with the
holes in the exhaust flange gasket (B). See figure 7.
10