Craftsman 973.111330 - Manual (Page 8)

OPÉRATION
SWITCH
See
Figure 2.
To turn youf drill ON, depress the switch trigger. To
turn it OFF, release the switch trigger.
SELECTOR
VARIABLE SPEED
This tool has a variable speed switch that detivers
higher speed and torque with increased trigger
pressure. Speed is controlled by the amount of switch
trigger depression.
Note: You might hear a whistling or ringing noise from
the switch during use. Do not be concerned, this is a
normal part of the switch function.
TO INSTALL BATTERY PACK
■ Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 2.
• Place battery pack in your drill. Align raised rib
inside drill with groove on battery pack. See
Figure 3.
LATCHES
DEPRESS LATCHES
TO RELEASE
BATTERY PACK Fig. 3
■ Make sure the latches on each side of your
battery pack snap in place and battery pack is
secured in drill before beginning operation.
CAUTION: When placing battery pack In your
drill, be sure raised rib inside drill aligns with
groove on battery paok and latches snap in place
properly. Improper assembly of battery pack can
cause damage to Internal components.
TO REMOVE BATTERY PACK
■ Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 2.
■ Locate latches on end of battery pack and
depress to release battery pack from your drill.
See Figure 3.
■ Remove battery pack from your drill.