Craftsman 973.111330 - Manual (Page 5)

■ An extension cord should not be used unless
absolutely necessary. Use of improper
extension cord could result in a risk of fire and
electric shock. If extension cord must be used,
make sure:
a. That pins on plug of extension cord are the
same number, size and shape as those of
plug on charger.
b. That extension cord is properly wired and in
good electrical condlbon; and
c. That wire size is large ertough for AC
ampere rating of charger as specified
below:
Cord Length (Feet) 25' 50' 100'
Cord Size (AWG) 16
16 16
Note: AWG ^ American Wire Gage
■ DO NOT OPERATE CHARGER WITH A
DAMAGED CORD OR PLUG. If damaged,
have replaced Immediately by a qualified
serviceman.
RULES FOR SAFE OPERATION (Continued)
Do not cerate charger if it has received a
sharp blow, been dropped, or otherwise
damaged in any way; take It to a qualified
serviceman.
Do not disassemble charger; take it to a
qualified serviceman when service or repair is
required, incorrect reassembly may result in a
risk of electric shock or fire.
To reduce risk of electric shock, unplug charger
from outlet before attempting any maintenance
or cleaning. Turning off controls will not reduce
this risk.
Do not use charger outdoors.
Disconnect charger from power supply when
not in use.
SAVE THESE INSTRUCTIONS. Refer to them
frequently and use them to instruct others who
may use this tool. If you loan someone this tool,
loan them these instnjctions also.
Look for this symbol to point out important safety precautions. It means attention!!! Your
** safety Is involved.
SAVE THESE INSTRUCTIONS
IMPORTANT INFORMATION FOR RECHARGING HOT BATTCRIES
When using your drill-driver continuously, the batteries In your battery pack will become hot. You should let a hot
battery pack cool down for approximately 30 minutes before attempting to recharge.
Note; This situation only occurs when continuous use of your drill causes the batteries to become hot. It does
not occur under normal circumstances. Refer to "CHARGING BATTERY PACK" lor normal recharging of
batterias. If the charger does not charge your battery pack under normal circumstances, return both the battery
pack and charger to your nearest Sears repair center for electrical check.
A WARNING;
The operation of any power tool can result In foreign objects being thrown into your eyes,
which can result in ssvere eye damage. Before beginning power tool operation, always wear
safety goggles or safety glasses with side shields and a full face shield when needed. We
recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses
with side shields, available at Sears Retail Stores.