Craftsman 315.228410 - Manual (Page 5)

INSTALLATION
INSTALLING THE FRONT RAIL
■ Locate the front rail and the following hardware:
Right and left end caps for front rail
2 screws (5/32-32 x 1/2 in.) for end caps
■ Set aside the end caps and two screws until the
switch has been installed.
Note: The square head bolts, washers, and hex nuts
shown at the bottom of figure 6 should still be
on the table saw. If you mistakenly removed
them, put them back on the table. Do not
tighten,
■ The back of the rail has two slots. See Figure 7.
Carefully slide the upper slot over the bolts.
(Bottom slot is for switch.)
■ Align the rail left to right - Match the 7-1/8 in, mark
on the right scale to the right edge of the saw base
(main table).
See Figure 8.
■ Snug the rail against table. Finger-tighten each nut
on the table and extensions.
TABLE TOP VIEWED FROM ABOVE
SAW TABLE
SCALE
i
TABLE
EXTENSION
\ \ K \ \ \ \ \ \ f f \ i \ t \ i K \ \ \ I \ \ K \ \ \ \ \ } ? ^ \ i \ I \ \ \
FRONT RAIL 7-1/8 in. MARK RIGHT SCALE
Fig. 8