Preparation – Craftsman 315.228410 User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PREPARATION
REMOVING THE SWITCH AND RAILS
■ Remove the front rail end caps.
■ Under the front rail, loosen the switch screws and
slide the switch off of the rail.
See Figure 2.
Note: Do not remove the switch screws completely.
Loosening the screws will allow you to slide the
switch off the front rail and the switch will be
ready to install on the new front rail.
SLOT FOR BOLT
TABLE EXTENSION
FRONT RAIL
'TABLE
EXTENSION
6----------------- SWITCH SCREW
SQUARE NUT
■ Remove the rear rail end caps.
■ Under the table, loosen all of the hex nuts on the
square head bolts that hold both front and rear
rails.
See Figure 3.
Note; Do not remove the hex nuts completely.
Loosening the nuts will allow you to slide the
rails off the table and the square head bolts will
be ready for the new rails.
■ Carefully slide the rails off of the bolts and the
table.
Fig. 2