Operation, A caution, Stopping the engine – Craftsman 247.889980 User Manual
Page 14: Awarning, Engaging the drive, Engaging the blades, Operating on slopes
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

OPERATION
STARTING THE ENGINE
Refer to the Service and Maintenance section of this manual for
Gasoline and Oil fill-up instructions.
1.
Disengage all controls on the mower.
2.
Move the gear shift lever into the neutral (N) position.
3.
Insert the key into the ignition switch.
4.
If starting a cold engine, place the throttle/choke control all the
way forward, into the
CHOKE |x|
position. If restarting a warm
engine, place the throttle/choke control into the Fast V position.
5.
Turn the ignition key clockwise to the
START
(Q) position. After
the engine starts, release the key. It will return to the
RUN ^
position.
6.
Move the key to the
RUN/LIGHT
position to operate the
mower using the headlight. ""
A CAUTION
Do NOT hold the key in the
START
position for longer than five
seconds at a time. Doing so may cause damage to your engine’s
electric starter.
7.
Move the throttle/choke control into the
FAST
position.
NOTE:
Never leave the throttle/choke control in the
CHOKE M
position while operating the mower. Doing so will result in a “rich” fuel
mixture and cause the engine to run poorly.
Stopping the Engine
AWARNING
If you strike a foreign object, stop the engine and remove the ignition
key. Thoroughly inspect the machine for any damage. Repair the
damage before restarting and operating._ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
1.
If the blades are engaged, release the Blade Control.
2.
Move the throttle/choke control into the
STOP
@ position.
3.
Turn the ignition key counterclockwise to the
STOP
iQ) position.
4.
Remove the key from the ignition switch to prevent unintended
starting.
ENGAGING THE DRIVE
AWARNING
I
Avoid sudden starts, excessive speed and sudden stops.___________ |
Start the engine as instructed earlier in this section and move the
throttle/choke control into the
FAST ^
position.
To travel
FORWARD:
a.
Place the gear shift lever in any of the four forward ground
speeds. Select a speed appropriate for the conditions and a
pace you're comfortable with.
b.
Slowly squeeze the Drive Control against the left handle grip
and the mower will move. Release it and drive motion will stop.
To travel in
REVERSE,
a.
Check that the area behind is clear.
b.
Place the gear shift lever in Reverse (R).
c.
Slowly squeeze the Drive Control against the left handle grip
and the mower will move. Release it and drive motion will stop.
A CAUTION
Do NOT attempt to change the direction of travel when the mower is
in motion. Always release the drive control and bring the mower to a
complete stop before repositioning the gear shift lever from a forward
gear into Reverse. Failure to do so may result in serious damage to
your transmission.
AWARNING
Do not leave the operator’s position without first releasing the Blade
Control. If leaving the mower unattended, also turn the engine off and
remove the ignition key.
ENGAGING THE BLADES
AWARNING
To help avoid blade contact or a thrown object injury, keep bystand
ers, helpers, children and pets at least 75 feet from the machine while
it is in operation. Stop machine it anyone enters the area.
1.
Move the throttle/choke control to the
FAST ^
position.
2.
Slowly squeeze the Blade Control against the right handle grip
and the blades will engage. Release it and the blades will stop.
OPERATING ON SLOPES
Refer to the SLOPE GUIDE on page 5 to help determine slopes where
you may operate the mower safely.
AWARNING
Do not mow on inclines with a slope in excess of 15 degrees (a rise
of approximately 2-1/2 feet every 10 feet). The mower could overturn
and cause serious injury.
Mow across the face of slopes; never up and down.
Exercise extreme caution when changing direction on slopes.
Watch for holes, ruts, rocks, hidden objects, or bumps which can
cause you to slip or trip. Tall grass can hide obstacles.
Always be sure of your footing. A slip and fall can cause serious
personal injury. If you feel you are losing your balance, release
the blade control handle immediately and the blade will stop
rotating within three (3) seconds.
Do not mow near drop-offs, ditches or embankments, you could
lose your footing or balance.
Do not mow slopes greater than 15 degrees as shown on the
slope gauge.
Do not mow on wet grass. Unstable footing could cause slipping.
14