Craftsman 580.762250 - Manual (Page 3)

• Units with broken or missing parts, or without
protective housing or covers should NEVER be
operated.
• The muffler and air cleaner must be installed and
in good condition before operating the Pressure
Washer. These components act as spark
arrestors if the engine backfires.
• Check the fuel system for leaks or signs of deteri­
oration such as chafed or spongy hose, loose or
missing clamps or damaged tank or cap. Correct
all defects before operating the Pressure
Washer.
OPERATION:
Do not spray flammable liquids.
Never allow any part of the body to come in con­
tact with the fluid stream. DO NOT come in con­
tact with a fluid stream created by a leak in the
high pressure hose.
High pressure stream of fluid that this equipment
can produce can pierce skin and its underlying
tissues, leading to serious injury and possible
amputation.
Never aim the gun at people, animals or plants.
High pressure spray can cause paint chips or
other particles to become airborne and fly at high
speeas.
Always wear eye protection when you use this
equipment or when you are in the vicinity where the
equipment is in use.
Operate the pressure at no more than the PSI
fluid pressure rated for your pressure washer.
Never move the machine by pulling on the high
pressure hose. Use the handle provided on the
top of the unit.
Always be certain the spray gun, nozzles and
accessories are correctly attached.
Never use a spray gun which does not have a
trigger lock or trigger guard in place and in work­
ing order.
Use a respirator or mask whenever there is a
chance that vapors may be inhaled. Read all
instructions with the mask so you are certain the
mask will provide the necessary protection
against inhaling harmful vapors.
High pressure spray may damage fragile items
including glass. Do not point spray gun at glass
when in the jet spray mode.
Keep the hose connected to machine or the
spray gun while the system is pressurized.
Disconnecting the hose while the unit is pressur­
ized is dangerous.
Hold the spray gun firmly in your hand before you
start the unit. Failure to do so could result in an
injury from a whipping spray gun. Do not leave
the spray gun unattended while the machine is
running.
The cleaning area should have adequate slopes
and drainage to reduce the possibility of a fall
due to slippery surfaces.
Keep water spray away from electric wiring or
fatal electric shock may result.
Do not adjust unloader valve to a pressure in
excess of machine rating.
Do not secure trigger gun in the pull-back (open)
position.
Do not by-pass any safety device on this
machine.
The muffler and engine heat up during operation
and remain hot immediately after shutting it
down. Avoid contact with a hot muffler or engine
or you could be severely burned.
MAINTENANCE AND STORAGE:
• Operate and store this unit on a stable surface.
♦ High pressure hose can develop leaks from wear,
kinking, abuse, etc. Water spraying from a leak is
capable of injecting material into skin.lnspect
hose each time before using it. Check all hoses
for cuts, leaks, abrasions or bulging of cover, or
damage or movement of couplings. If any of
these conditions exist, replace hose immediately.
Never repair high pressure hose. Replace it with
another nose that meets minimum pressure rat­
ing of your pressure washer.
Note: In the State of California a spark arrestor is
required by law (Section 4442 of the California
Public Resources Code). Other states may have
similar laws. Federal laws apply on federal lands.
Note: If you equip the engine of your pressure wash­
er with a spark arrestor muffler, the spark arrestor
must be maintained in effective working order by the
owner/operator.
You can order a spark arrestor (part # 398067)
through your Sears Service Center.
A LOOK FOR THIS SYMBOL TO POINT OUT IMPORTANT SAFETY PRECAUTIONS.
IT MEANS “ATTENTION!!! BECOME ALERT!!! YOUR SAFETY IS INVOLVED.’