Set up instructions, Caster axle bolts, Setup instructions -20 – Craftsman 127.28876 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SET UP INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
-
Wrecking bar
-
Claw hammer
-
Sockets: 1/2”, 15/16
-
Wrenches: 18mm, 1/2”, 9/16”, 3/4”, 15/16”
-
Tire pressure gauge
NOTE:
All references below to the “right” or “left” are with respect to an operator at the controls.
1.
UNCRATE UNIT
a) Discard packing materials. Loosen the caster wheel axle bolts and bumper bolts to remove the shipping
brackets.
Discard shipping brackets.
b) Re-install and tighten bumper bolts.
c) Tighten caster wheel axle bolts against caster axle spanner bushings to 80 ft/lbs.
------------
■
>
/
#
CASTER AXLE BOLTS
2.
TIRE PRESSURE
a) Set tire pressures to 14 Ibs/in^ (1.0 kg/cm^). Tires are overinflated for shipping.
3.
TRACTION LEVERS
a) Tighten bolt
A.
b) Sit on the machine. Levers
C
may be moved to
upper set of holes in bar B for a better operator
fit.
19