Craftsman 315.216360 - Manual (Page 17)

OPERATION
LOCK POST
See Figure 17.
To prevent unauthorized use of your scroll saw, we
suggest that you disconnect it from the power supply
and lock the knob in the OFF position. A Master
Lock® 105D padlock should be used. When the lock
is installed and locked, as illustrated, the switch is
inoperable. Store the padlock key in another location.
■ To lock the saw in the OFF position, install a
padlock through the lock post beside the knob as
illustrated and lock the padlock. (Padlock is not
supplied with the saw.)
A WARNING: For your own safety, always push
the knob OFF when machine is not in use. Also,
in the event of a power failure, push knob OFF.
Lock the scroll saw switch OFF with a padlock.
This will prevent the machine from starting up
again when the power comes back on. Failure to
heed this warning can result in serious personal
injury.
INTERIOR SCROLL CUTTING
See Figure 16.
■ One of the features of a scroll saw is that it can
be used to make scroll cuts on the interior of a
board without breaking or cutting through the
edge or perimeter of the board.
WARNING: To avoid possible serious injury
from accidental starting, always turn the switch
OFF and remove plug from power source outlet
before removing or replacing the blade.
■ To make interior cuts in a board, remove the
scroll saw blade as explained in the Installing
Blades section on page 14.
■ Drill a 1/4 in. hole in the board to be used to
make interior cuts.
■ Place the board on the saw table with the hole in
the board over the access hole in the table.
■ Install blade through hole in board then adjust
the hold down foot and the blade tension. See
pages 14 and 15.
■ When finished making the interior scroll cuts,
simply remove the blade from the blade holders
as described in the Installing Blades section,
and remove the board from the table.
DRILL HOLE
INTERIOR
CUT
ON/OFF KNOB
Fig. 18
17