Craftsman 358.794772 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
THROTTLE POSITION LEVER
The THROTTLE POSITION LEVER is de
signed to allow setting engine speed
during blower use only. To avoid caus
ing damage to the unit, DO NOT at
tempt to use the throttle position lever
during vacuum use.
PRIMER BULB
The PRIMER BULB removes air from
the carburetor and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope. Activate primer bulb by
pressing it and allowing it to return to
its original position.
START LEVER
The START LEVER helps to supply fuel
to the engine to aid in starting. Activate
the starting system by moving the start
lever to the START position. DO NOT
squeeze the throttle trigger until the
engine has started and runs. After the
engine starts, allow the engine to
warm-up 10-15 seconds, then fully
squeeze the throttle trigger to deacti
vate the starting system (start lever re
turns to RUN position).
OPERATING TIPS
• While vacuuming or blowing debris,
hold the unit with the muffler side fac
ing away from your body and clothes
(see OPERATING POSITION below).
• To reduce the risk of hearing loss
associated with sound level(s), hear
ing protection is required,
• To reduce the risk of injury associated
with contacting rotating parts, stop the
engine before installing or removing
attachments. Do not operate without
guard(s) in place.
• Operate power equipment only at rea
sonable hours-not early in the morn
ing or iate at night when people might
be disturbed. Comply with times listed
in local ordinances. Usual recommen
dations are 9:00 a.m. to 5:00 p.m.,
Monday though Saturday,
• To reduce noise levels, limit the num
ber of pieces of equipment used at
any one time,
• To reduce noise levels, operate pow
er blowers at the lowest possible
throttle speed to do the job.
• Use rakes and brooms to loosen
debris before blowing.
• In dusty conditions, slightly dampen
surfaces or use a mister attachment
when water is available.
• Conserve water by using power blow
ers instead of hoses for many lawn
and garden applications, including
areas such as gutters, screens, patios,
grills, porches, and gardens.
• Watch out for children, pets, open
windows, or freshly washed cars.
Blow debris away safely,
• Use the full blower nozzle extension
so the air stream can work close to
the ground.
• After using blowers and other equip
ment, CLEAN UPl Dispose of debris
in trash receptacles.
OPERATING POSITION
BEFORE STARTING ENGINE
^WARNING:
Be sure to read the
fuel information in the safety rules
before you begin. If you do not
understand the safety rules, do not
attempt to fuel your unit. Cali
1 -800-235-5878.
FUELING ENGINE
^WARNING: Remove fuel cap
slowly when refueling.
This engine is certified to operate on un
leaded gasoline. Before operation, gaso
line must be mixed with a good quality
synthetic 2-cycle air-cooled engine oil.
Vife recommend Craftsman brand syn
thetic oil. Mix gasoline and oil at a ratio
of 40:1. A 40:1 ratio is obtained by mix
ing 3.2 ounces of oil with 1 gallon of un