Craftsman 358.794772 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ENGINE
• Remove spark plug and pour 1 tea
spoon of 40:1,2-cycle engine oil (air
cooled) through the spark plug open
ing. Slowly puli the starter rope 8 to
10 times to distribute oil,
• Replace spark plug with new one of
recommended type and heat range.
• Clean air filter.
• Check entire unit for loose screws,
nuts, and bolts. Replace any dam
aged, broken, or worn parts,
• At the beginning of the next season,
use only fresh fuel having the proper
gasoline to oil ratio.
OTHER
• Do not store gasoline from one sea
son to another.
• Replace your gasoline can if it starts
to rust.
TROUBLESHOOTING TABLE
A WARNING:
Always stop unit and disconnect sparkplug before perform
ing any of the recommended remedies below otherthan remedies that re
quire operation of the unit.
TROUBLE
CAUSE
REMEDY
Engine will not
start.
1. Engine flooded.
2. Fuel tank empty,
3. Spark plug not firing.
4. Fuel not reaching
carburetor.
5. Compression low.
1, See “Starting a Flooded Engine"
in Operation section.
2, Fill tank with correct fuel mixture.
3- Install new spark plug.
4, Check for dirty fuel filter; replace.
Check for kinked or spilt fuel line;
repair or replace.
5, Contact Sears Service (see back cover).
Engine will not
idle properly.
1. Fuel not reaching
carburetor.
2. Carburetor requires
adjustment.
3. Crankshaft seals worn.
4. Compression low.
1, Check for dirty fuel filter; replace.
Check for kinked or spilt fuel line;
repair or replace.
2- Contact Sears Service (see back cover).
3, Contact Sears Service (see back cover).
4, Contact Sears Service (see back cover).
Engine will not
accelerate,
lacks power, or
dies under a
load.
1. Air filter dirty.
2. Fuel not reaching
carburetor.
3. Spark plug fouled.
4. Carburetor requires
adjustment.
5. Carbon build up.
6. Compression low.
1. Clean or replace air filter.
2. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
3. Clean or replace spark plug
and re-gap.
4. Contact Sears Service (see back cover).
5. Contact Sears Service (see back cover).
6. Contact Sears Service (see back cover).
Engine smokes
excessively.
1, Choke partially on.
2. Fuel mixture incorrect.
3. Air filter dirty.
4, Carburetor requires
adjustment.
1, Adjust choke.
2, Empty fuel tank and refill with
correct fuel mixture.
3, Clean or replace air filter.
4, Contact Sears Service (see back cover).
Engine runs hot. 1, Fuel mixture incorrect.
2, Spark plug incorrect.
3, Carburetor requires
adjustment.
4- Carbon build up.
1. See “Fueling Engine” in Operation
section.
2. Replace with correct spark plug.
3. Contact Sears Service (see back cover).
4. Contact Sears Service (see back cover).
14