Craftsman 917.28907 - Manual (Page 9)

7. Lower seat into operating position and
sit on seat. Press clutch/brake pedal all
the way down. If operating position is not
comfortable, adjust seat.
TO ADJUST SEAT
Grasp adjustment handle and pull up, slide
seat to desired position and release adjust­
ment handle.
NOTE: You may now roll your tractor off
the skid. Follow the appropriate instruction
below to remove the tractor from the skid.
A WARNING: Before starting, read, un­
derstand and follow all instructions in the
Operation section of this manual. Be sure
tractor is in a well-ventilated area. Be sure
the area in front of tractor is clear of other
people and objects.
TO ROLL TRACTOR OFF SKID
(See Operation section for location
and function of controls)
1. Raise attachment lift lever to its highest
position.
2. Release parking brake by depressing
clutch/brake pedal.
3. Place gearshift lever in neutral posi­
tion.
4. Roll tractor forward off skid.
5. Remove banding holding the deflector
shield up against tractor.
Continue with the instructions that follow.
CHECK TIRE PRESSURE
The tires on your tractor were overinflated at
the factory for shipping purposes. Correct
tire pressure is important for best cutting
performance.
• Reduce tire pressure to PSI shown on
tires.
CHECK DECK LEVELNESS
For best cutting results, mower housing
should be properly leveled. See “TO LEVEL
MOWER” in the Service and Adjustments
section of this manual.
CHECK FOR PROPER POSITION OF
ALL BELTS
See the figures that are shown for replacing
motion and mower blade drive belts in the
Service and Adjustments section of this man­
ual. Verify that the belts are routed correctly.
CHECK BRAKE SYSTEM
After you learn how to operate your tractor,
check to see that the brake is operating
properly. See “TO CHECK BRAKE” in the
Service and Adjustments section of this
manual.
CHECKLIST
Before you operate your new tractor, we
wish to assure that you receive the best
performance and satisfaction from this
Quality Product.
Please review the following checklist:
y
All assembly instructions have been
completed.
y
No remaining loose parts in carton.
y
Battery is properly prepared and
charged.
y
Seat is adjusted comfortably and tight­
ened securely.
y
All tires are properly inflated. (For ship­
ping purposes, the tires were overinflated
at the factory).
y
Be sure mower deck is properly leveled
side-to-side/front-to-rear for best cutting
results. (Tires must be properly inflated
for leveling).
y
Check mower and drive belts. Be sure
they are routed properly around pulleys
and inside all belt keepers.
y
Check wiring. See that all connections
are still secure and wires are properly
clamped.
While learning howto use yourtractor, pay ex­
tra attention to thefollowing important items:
y
Engine oil is at proper level.
y
Fuel tank is filled with fresh, clean, regular
unleaded gasoline.
y
Become familiar with all controls, their
location and function. Operate them
before you start the engine.
y
Be sure brake system is in safe operating
condition.
y
Be sure Operator Presence System and
Reverse Operation System (ROS) are
working properly (See the Operation and
Maintenance sections in this manual).