Assembl, See figure 19 – Craftsman 315.284610 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBL
j
To adjust (horizontally):
■ Remove the blade guard assembly and antl-kickback
pawls.
■ Raise the blade to Its full height.
■ Insert the hex key through the slot on the back of the
saw. Two adjustment screws can be accessed through
the slot.
■ Turn the adjustment screws to reposition the spreader/
riving knife left or right as needed to align the spreader/
riving knife with the saw blade.
■ Once properly aligned, securely retIghten the screws.
To adjust (vertically):
■ Push either side of the riving knife to align It top
to bottom with the blade. Check Its position after
adjustment to ensure that It Is vertically aligned with
the blade.
HORIZONTAL ADJUSTMENT
FRAMING
SOUARE
SOUARE
PUSH STICK STORAGE
See Figure 19.
■ Insert the push stick storage screws from the loose
parts bag Into the holes on the side of the saw table.
Use a Phillips head screwdriver to tighten screws
securely.
■ Place the slots In the push stick over the screws and
slide the push stick toward the back of the saw.
PUSH STICK STORAGE
SCREW(S)
Fig. 19
22