Unpacking, Loose parts list, Tools needed – Craftsman 315.214500 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

UNPACKING

WARNING:

To prevent accidental starting that

could cause possible serious personal injury,
assemble all parts to your saw before connecting

it to power supply. Saw should never be

connected to power supply when you are

assembling parts, making adjustments, installing

or removing blades, or when not in use.

Carefully remove all parts from the carton and

place the saw on a level work surface. Separate

and check against the list of loose parts.

WARNING:

If any parts are missing, do not

operate this tool until the missing parts are

replaced. Failure to do so could result In possible

serious personal injury.

■ Do not discard the packing materials until you

have carefully inspected the saw, identified all

parts, and satisfactorily operated your new saw.

Note:

If any parts are damaged or missing, do not

attempt to plug in the power cord and turn the switch

on until the damaged or missing parts are obtained

and are installed correctly.

LOOSE PARTS LIST

ymm

Check all loose parts from the box with the list below. For your convenience when identifying parts, items A-H

below have been drawn actual size. Assemble according to the instructions on the following pages.

A. Flat Head Screw (1/4-20 x 7/8 in.).................................3

B. Hex Nut (1/4-20)............................................................. 3

C. Wing Nut (1/4-20)...........................................................1

D. Truss Head Screw (1/4-20 x 5/8 in.)............................. 1

E. Screw (M5 x 8)............................................................... 1

F. Scale Indicator.............................................................. 1

G. Throat Plate................................................................... 1

H. Hex Key (1/8 in.)............................................................ 1

Saw Table (not shown)................................................. 1

Owner's Manual (not shown)....................................... 1

Fig. 2

TOOLS NEEDED

The following tools (not included) are needed for

assembly and alignment:

• #2 Phillips Screwdriver

• Adjustable Wrench

■ Small Combination Square

• 5/16 in. Socket or Nut Driver

SMALL

COMBINATION

SQUARE

#2 PHILUPS SCREWDRIVER

5/16 in. SOCKET/NUT DRIVER

Fig. 3