Craftsman 917.276240 - Manual (Page 9)

5 .
6 .
8 .
9.
Place seat on seat pan so head of
shoulder bolt is positioned over large
slotted hole in pan.
Push down on seat to engage shoulder
bolt in slot and pull seat towards rear of
tractor.
Pivot seat and pan forward and as­
semble adjustment knob and flat
washer loosely. Do not tighten.
Lower seat into operating position and
sit in seat.
Slide seat until a comfortable position
is reached which allows you to press
clutch/brake pedal all the way down.
Get off seat without moving its ad­
justed position.
Raise seat and tighten adjustment
knob securely.
NOTE: You may now roll or drive your
tractor off the skid. Follow the appropriate
instruction below to remove the tractor
from the skid.
TO ROLL TRACTOR OFF SKID (See
Operation section for location and
function of controls)
1. Press lift lever plunger and raise
attachment lift lever to its highest po­
sition.
2. Release parking brake by depressing
brake pedal.
3. Place freewheel control in disengaged
position to disengage transmission
(See “TO TRANSPORT” in the Op­
eration section of this manual).
4. Roil tractor forward off skid.
TO DRIVE TRACTOR OFF SKID (See
Operation section for location and
function of controls)
^WARNING: Before starting, read, un­
derstand and follow all instructions in the
Operation section of this manual. Be sure
tractor is in a well-ventilated area. Be sure
the area in front of tractor is clear of other
people and objects.
1. Be sure all the above assembly steps
have been completed.
Check engine oil level and fill fuel tank
with gasoline.
Place freewheel control in "trans­
mission engaged" position (see "TO
TRANSPORT" in Operation section of
this manual).
Sit on seat in operating position, de­
press brake pedal and set the parking
brake.
Press lift lever plunger and raise
attachment lift lever to its highest posi­
tion.
Start the engine. After engine has
started, move throttle control to idle
position.
Release parking brake.
Slowly move the motion control lever
forward and slowly drive tractor off
skid.
Apply brake to stop tractor and set
parking brake.
10.Turn ignition key to "STOP" position.
Continue with the instructions that follow.
2
.
3.
4.
5.
6 .
7.
8 .
9.