Country Home Products DR - Manual (Page 34)

30 DR  COMMERICAL LEAF and LAWN VACUUM Safety & Operating Instructions
Figure 25
Dumping
1. Disconnect the Collector Box Hose from the
Blower Exit Elbow by releasing the two flexible
latches (Figure 34) and separate the hoses.
2. Remove the Rear Panel of the Collector Box by
releasing the six (6) fasteners located at the sides,
top and bottom of the panel. Lift the Rear Panel
off the mounting pins on the Collector Box
Cover.
3. While holding down on the Dump Handle, pull
the Dump Lever (Figure 35) to unlock the Tilt
Bed and then raise the Tilt Bed using the Dump
Handle (Figure 36).
4. After dumping the load, lower the Tilt Bed until
the Dump Lever locks into place (Figure 36), and
replace the Rear Panel.
5. Re-connect the Collector Box Hose to the
Blower Exit Elbow.
Figure 35 Figure 36
Pull Dump Lever
WARNINGS!
Always shut off the tractor engine and the vacuum engine and use caution when
dumping the Collector Box load.
The load may have shifted against the rear panel. Push down on the Dump
Handle when releasing the Dump Lever to prevent the Tilt Bed from suddenly
tipping.
Blower Exit Elbow
Pull & Unhook Latches
Collector
Box Hose
Figure 34
Hold
Down
Dump
Handle Dump
Handle
Locked
Position